Rikon Power Tools 50-151 Instrukcja Operatora

50-151www.rikontools.com50-151M21” X 30” Belt / 5” Disc SanderOperator’s ManualRecord the serial number and date of purchase in your manual for future

FIG. AFIG. B10ASSEMBLYASSEMBLY AND INSTALLATION Always ensure the sander is unplugged prior to attempting any assembly, installation or changing of pa

11FIG. EFIG. FFIG. DASSEMBLING THE SANDING DISC TABLE Always ensure the sander is discon-nected from the power supply prior to commencing work.1. Atta

12INSTALLING & CHANGING SANDING DISCS Turn the power off and remove the plug from the outlet before changing the accessories.DISC TABLE ADJUSTMENT

13INSTALLING & CHANGING SANDING BELTS Turn the power off and remove the plug from the outlet before changing the accessories.SANDING BELT REMOVAL:

14GENERAL USE AND OPERATING INSTRUCTIONSON/OFF SWITCHThe rocker ON/OFF power switch is located on the front of the sander.1. Press the side marked ON

15TROUBLESHOOTINGService on these tools should only be performed by an authorized, qualied technician.SYMPTOM PROBABLE CAUSE CORRECTIVE ACTIONMotor w

SYMPTOM PROBABLE CAUSE CORRECTIVE ACTIONBurn marks on workpiece. 1. Using a sanding grit that is too ne.2. Using too much pressure.3. Work held st

PARTS EXPLOSION17

PARTS LIST18ACCESSORIESSANDING BELTS 1” x 30” Aluminum Oxide50-9080 80 Grit Pack of 1050-9120 120 Grit Pack of 1050-9150 150 Grit Pack o

WARRANTY19WARRANTY

2TABLE OF CONTENTSSPECIFICATIONSSpecications ...

www.rikontools.com50-151M250-151For more information:16 Progress RdBillerica, MA 01821877-884-5167 / [email protected]

The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols and the explanations with them deserve your careful

4IMPORTANT! Safety is the single most important consideration in the operation of this equipment. The following instructions must be followed at all t

5SAFETY INSTRUCTIONS 16. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to the “OFF” p

6SAFETY INSTRUCTIONS ELECTRICAL SAFETY (Continued)DO NOT MODIFY THE PLUG PROVIDED. If it will not t

SPECIFIC SAFETY INSTRUCTIONS FOR BELT & DISC SANDERSSAVE THESE INSTRUCTIONS.Refer to them often.7 1. Do not operate this machine until you have r

Carefully unpack your sander from its carton, and check to make sure the following parts are included. If any parts are missing or broken, please call

GETTING TO KNOW YOUR SANDERABCDEFGHIJKL9ASSEMBLYTHE SANDER MUST NOT BE PLUGGED IN AND THE POWER SWITCH MUST BE IN THE OFF POSITION UNTIL ASSEMBLY IS C